Psychobike banner

1 - 11 of 11 Posts

·
Registered
Joined
·
373 Posts
Discussion Starter · #1 ·
So I have gen 1 and wanting to do the stock super sport where the hump is molded in. Wanting to know if i can make this work on the gen1 subframe or is it not that easy and I will be street riding so i need a front seat will gen 1 work or need gen2 front seat and tail light to?
 

·
Registered
Joined
·
1,539 Posts
you want to run a gen 1 or gen 2 tail?
 

·
Registered
Joined
·
380 Posts
u will need the Gen II rear subframe, tail light, cowl and passenger pegs
 

·
Registered
Joined
·
373 Posts
Discussion Starter · #8 ·
I have read both u can use stock subframe and just have to cut off the rear mounts and have them moved and 1 1/4 of and inch and it fits fine and if that's true that tail I don't need the stock rear mounts I can use a quick release and make a mount in the middle of the hump
 

·
Registered
Joined
·
380 Posts
ok u do that. let us know how it pans out....
 

·
Registered
Joined
·
1,367 Posts
I have put many genn 2 tails on genn 1 subframe
yes will have to cut off the rear mounts off subframe
and grind flush or will put pressure on tail and crack where it touches
then need to trim the lower wings at front mount where hits frame for the angle difference
then make a rear mount out if flat allum bolted to the rear bolts on subeframe and use zeus fastner
if going to ride on street better add a front brace on the old seat pan bolts bent to hit bottom of seat area
and have extra glass put in seat pan areaas will crack up there if not braced and extra thick,,,,,,,,,
 
1 - 11 of 11 Posts
Top