Psychobike banner

1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Hi everybody. I have been reading the forum for years and it has been a great help.

Now im almost finished buildin my "street" drag gsxr.

Bike dies when at full throttle. It revs great with about 60% throttle but when it goes past that it cuts out and revs about 6500rpm

Problem is i have a bosch map sensor in the plenum. Its communicating with pc5 and boost mapped. The signal wire from the original harness is cut and showing c13 code.

Can 1 just solder the original signal wire to the signal wire from map to pc5 to shut remove the code?Without destroing the ecu?

The bike is self build low compression Motor and made 290 [email protected] 12.4 psi of boost at the dyno. Thanks
264546
264547
 
1 - 1 of 1 Posts
Top