Psychobike banner

1 - 6 of 6 Posts

·
Registered
Joined
·
18 Posts
Discussion Starter #1
who sells a good after market fuel system for a busa complete not to expensive just a little street bike but packs a hellva punch all motor but can take gas dry or wet but for now all motor:2thumbs:
 

·
Premium Member
Joined
·
63 Posts
you dont need a fuel system unless your going big bore.squeeze the regulator to up the fuel pressure to 50-60 psi. if your spraying stock motor only go 40 shot or smaller. stock rods wont take too big of shot.
 

·
Registered
Joined
·
379 Posts
wait till you start spraying more often,and u can spray more than 40 dry...make sure u run good fuel though.:2thumbs: then when youre ready for abig system build:2thumbs: your own way cheaper and simpler than you would think
 

·
Registered
Joined
·
18 Posts
Discussion Starter #4
fuel pressure regulator

what side do you crush or squeeze i was told to use a nine mm socket but on what side :2thumbs:
 

·
Premium Member
Joined
·
63 Posts
look on the side with spring. thats the side you put socket.put in a vise and crush..i think it is .030...i did mine last year and got 60 psi..factory is 43...or you can put a add in wanted parts for a crushed one..
 

·
Registered
Joined
·
1,077 Posts
look on the side with spring. thats the side you put socket.put in a vise and crush..i think it is .030...i did mine last year and got 60 psi..factory is 43...or you can put a add in wanted parts for a crushed one..

i have one if someone is interested.
08 busa pump...
 
1 - 6 of 6 Posts
Top