Psychobike banner

1 - 9 of 9 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter · #1 ·
Decided to go with a 05-06 cable setup for the clutch on my 07 gsxr. My problem was I used the rod from the 06 but is still 1/4 inch too long. Is it suppost to be a perfect fit or do I have to shave the extra 1/4 inch off?
 

·
Registered
Joined
·
277 Posts
the 05 and 06 inner baskets are different and yes the rod is fine
 

·
Registered
Joined
·
12 Posts
Discussion Starter · #3 ·
I'm just using the cable, cover and push rod. The rod ended up sticking out 1/4 inch further out and couldnt install cover without pushn rod in. So wondering if something is meson the rod from goin all the way in. Or if I need to just shim off he extra to get the cover on
 

·
Registered
Joined
·
12 Posts
Discussion Starter · #4 ·
The 04 shaft doesn't go in as deep on the 07 motor as in the 04. It needs about 1/4 inch and that's the amount that I need for cover to bolt on
 

·
Premium Member
Joined
·
160 Posts
yes just did the same thing trim the rod down make sure you smooth the edge and put the stock side in so it dont tear the seal
 

·
Registered
Joined
·
277 Posts
The push rod and the rod inside the trans shaft is different from the 07
 

·
Registered
Joined
·
214 Posts
How much needs to be trimmed? I'm looking at doing this also. Got all the parts just need to put it together.
 
1 - 9 of 9 Posts
Top