[Haniffxwrth]

Sent from my VS910 4G using Xparent SkyBlue Tapatalk 2

 

[Haniffxwrth]

Mock up turned out pretty good.

Sent from my VS910 4G using Xparent SkyBlue Tapatalk 2

 

[shorttrack]

looks good.

 

[Haniffxwrth]

Sent from my VS910 4G using Xparent SkyBlue Tapatalk 2

 

[slo poke]

I have been trying to do this what all is needed to make it work

 

[Haniffxwrth]

Hey slo poke Get up with SLACK and he will tell you everything u need to know.

Sent from my VS910 4G using Xparent SkyBlue Tapatalk 2

 

[Haniffxwrth]

finished

Sent from my VS910 4G using Xparent SkyBlue Tapatalk 2

 

[nome555]

what all was needed to do this swap

 

[Haniffxwrth]

06 zx10 wheel set, rear zx10 axle. Thats it

Sent from my VS910 4G using Xparent SkyBlue Tapatalk 2

 

[vailes3705]

Looks good. How much weight is saved by doing the swap?

 

[Haniffxwrth]

I would say anywhere from 4-5lbs.

Sent from my VS910 4G using Xparent SkyBlue Tapatalk 2

 

[vailes3705]

I would say anywhere from 4-5lbs.

Sent from my VS910 4G using Xparent SkyBlue Tapatalk 2

That's not bad at all. May have to do this to mine.

 

[sweetride10r]

06 zx10 wheel set, rear zx10 axle. Thats it

Sent from my VS910 4G using Xparent SkyBlue Tapatalk 2

the front wheel was a derect bolt on??? no special spacers needed?

 

[Flyingbrick]

This is a ten year old thread but iv just signed up to try find a little more info on the swap. @Haniffxwrth are you still around?

 

[Flyingbrick]

Okay so if anyone finds this during a search like I did.. yup, they fit. You need to machine up a spacer that's slightly different in length to the stock busa one, but it's a minor. Then just use 2mm spacers to push each disk out (I used 2mm thick aluminium washers). I saved 580g of rotating unsprung mass by doi

ng this front wheel on my gen2 (I also used titanium disc bolts)
Nice and easy, highly recommend.