Psychobike banner

1 - 2 of 2 Posts

·
Registered
Joined
·
16 Posts
Discussion Starter #1
2004 Turbo Hayabusa for Sale - $11,000

Steve Knecum built motor

CP Pistons

Carrillo rods

Carpenter head work

roller cam chain conversion

Clutch cylinder support

MTC Billet clutch basket + inner hub+ 2 stage lockup

Robinson large output shaft trans with all size sprockets 16 to 19

Trac Dynamics swing arm

Galfer rotors and pads – all braided lines

Penske double adjustable shock

Fresh paint with factory stickers cleared over

Tuned by Mike Tona @SAE -248rwhp at 7lbs, also made 330 rwhp @ 11lbs

RCC Stainless Header

RCC quick access clutch cover

RCC oil scavenging pump

Wego data logger

Dump pipes and full exhaust w/custom stainless can

2 seats - 1-drag race low cut and 2- higher for more padding

hump in place of rear seat

turbosmart waste gate, 7lb = current, + 3lb and 5 lb springs

PC V

Boost by Smith gear counter, air shifter, w/auto option and compressor in tail

Tall wind screen

carbon wheel hugger

Ceramic wheel bearings

Aluminum adjustable kickstand

low peg mounts on swing arm, if your tall like me w/pegs

Tiger tail

Great street bike, drag race or land speed, take your pick

Less than 700 miles on all new motor, parts and paint.

Spare parts that are included:

Stock swingarm w/built in air tank and extenders = $250

stock rear shock = $250
850 lb Penske spring - $50
full exhaust w/custom stainless can for – value = $400

Low padded seat for racing–value = $50

Rear seat -$100
Turbo smart waste gate springs 3+5lb – $20

Stock windscreen – value = $50
Stock kickstand – value = $25
Billet Aftermarket gas cap – value = $25
Pegs for swing arm – value = $20
Spare new turbo cartridge – value = $500

Complete set of new / used clutch plates – value = $100

MTC chrome hardened steels plates – value = $50

Spare side panels used condition – value = $100

Schnitz front end tie down for drag racing - value = $10

17, 18, and 19 tooth front large shaft sprockets – Robinson – value = $300?

Tiger racing Hayabusa engine stand – value = $100

New chain to extend the wheelbase to 68in – value = $150

Roaring Toyz adjustable dog bones – value = $50

Mr gasket new exhaust turbo gaskets - value = $40

Stock / Modified by MTC clutch cover to fit lockup – value = $100

38 tooth rear sprocket for land speed racing – value = $50

Ballistic battery charger- balance cells – value $100

Converti Handle bars – value = $300


I am in CT.

[email protected]
 
1 - 2 of 2 Posts
Top