Psychobike banner

1 - 4 of 4 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter #1
do they have an idle screw to adjust? mine idles at about 1000-900 rpm. would removing the exhaust back pressure valve cause this? the previous owner put the slip-on on the bike and "deleted" the valve...
 

·
Registered
Joined
·
157 Posts
Pull the tank up and you will have a screw on the throttle bodies by the throttle cables.
 

·
Registered
Joined
·
137 Posts
Pull the tank up and you will have a screw on the throttle bodies by the throttle cables.
:2thumbs: It's the bottom of the two screws on left side of throttle bodies. Has two throttle cables connected. Turn screw clockwise I believe. Raise idle to around 1200-1300.
Make sure bike is at operating temperature before making any adjustments!
 

·
Registered
Joined
·
6 Posts
Discussion Starter #4
:2thumbs: It's the bottom of the two screws on left side of throttle bodies. Has two throttle cables connected. Turn screw clockwise I believe. Raise idle to around 1200-1300.
Make sure bike is at operating temperature before making any adjustments!
Thanks for the info i will add it to the list for this weekend! Wish i had a PC3 to put in with my bazzaz TRE...i would like to only take it apart once...
 
1 - 4 of 4 Posts
Top