Gen1 talldeck MTC pistons ( turbo ) WTB

[proutyc]

As title says looking to build a spare motor for my mate race setup. I plan to put a Gen2 crank that's spare with short Carrillo's so looking for a goood used set of 81mm MTC eng tall deck turbo pistons

Many thanks in advance

[proutyc]

Any other brand good used pistons?

Was hoping to install 08 crank and -2.5mm rods in spare engine so gather I could install small shim to get raight ratio

Thanks

[proutyc]

Anyone one got any tall deck Gen1 turbo pistons or something I could use on the below package.

Building a spare engine and whoch has a Gen2 crank and my spare -2.5mm carrillos so a turbo piston I can get close to 10 or 11:1 compression. Engine run on E85 and only 8 psi

As its a spare I hope I dont need to go new.

Mate also still looking for any single Carrillo Rods (Gen1 stock length or minus 2.5mm) or a Gen1 knife rod

thanks in advance

[proutyc]

Still looking for some Gen1 piston for a Gen1 turbo project running E85 (spare motor) I'm looking to try and get around 10.5 - 11:1 comp ratio. Please let me know if you have any good used pistons that I could use

Thanks

[pxmtuner]

You will be nowhere close to that comp ratio with a tall deck turbo mtc piston. Better go with the tall deck flat tops if you are trying to get that much comp on stock bore. :thumbup:

[proutyc]

Thanks for that.

I think my MTC pistons are currently 10.5:1 (but these are drop in ones)

[proutyc]

Still looking. Will consider tall deck high compression too

Thanks

[Relentless05]

i have a set of mtc with buttons but they are 1363 also a set of je turbo pistons 1363 text me 2292513364