07 zx10 nitrous install Help

[viper1]

I have installed a nitrous setup on my o7 zx10. But now I am haveing some trouble getting my TPS/window box working right. The real issue I am haveing is finding the correct wire to hook into for my TPS. My main TPS has 3 wires comeing from it and i know I am looking for a wire with a rotating voltage 0 Volts at idle and around 5 volts at WOT.

I am only getting a reading on one wire and it reads 5 volts all the time no matter where the throttle is turned and of course this makes my nitrous controller think it it WOT all the time which is very bad!!! I do not get any reading off the other two wires at any time.

Has anyone wired into the TPS on a 06/07 ZX10 if so where did you find the right voltage.

Please help!

[shoyass]

Make life easier just buy a WOT switch. You can get one from Schnitz or one of the site sponsors. It mounts to the Throttle bodies So when you pin the throttle it activates the switch and then your controller

[TIM HOLDEN]

Theres no room for that switch. I have a tprs hooked up to an 08 zx10. I will let you know what wire to hook to when i get home.

[viper1]

Yeah I think it would be a even bigger challenge to install a WOT switch. Tim Holden If you no what wire you hooked into it would be alot of help. I talked to a local proformance shop and they told me that yes one of the wires has a 5 Volt signal all the time and that is not the one to use of course. They could not tell me witch one of the other two it was but at least I have ruled one out. But it does consern me that I am still not getting any voltage signal from the other two at anytime but the bike still cranks and runs find so I am lost.

[6002abusa]

online wiring diagram?