Turbo header

[1397BusaDK]

Do you think this header will work with my Gt3582r ?

I will put the wg on the turbo

[sa9023]

Assuming your turbo has a v-band turbine housing, yes. It appears to be a 35r in the picture.

[1397BusaDK]

It is my turbo on the pic. I build the header but have no technical knowledge of headers, I just built it from what I've seen around

[B-RACER]

looks like it should..I would build support brackets to hold turbo ect on both sides..

[Oz Booster]

As someone that makes a couple a yr that looks good :) , going to drain well too

If you do another in future try tilting the outside pipes toward the centre more gives a straighter shot into the turbo , makes the flange bolts easier to get at and gives more room for the up pipe

[Gsx-rboy750]

As someone that makes a couple a yr that looks good :) , going to drain well too

If you do another in future try tilting the outside pipes toward the centre more gives a straighter shot into the turbo , makes the flange bolts easier to get at and gives more room for the up pipe

Totally agree with Oz Booster.
I going to do a TiAL ss turbo and my header will look pretty much like that except for the more slanted outside pipes like he said. I will flip my turbo the other way also.
Nice lookIng header!!
I am going to wastegate off the turbine housin again. You?

[1397BusaDK]

I will see if it will be a problem with the outside pibes be so right on, I can see that the flow will be better if they got a better angle.
my WG is 44mm and the pipe is welded outside and inside the turbine housin.

[B-RACER]

Nice!!..def make some brackets to support all that,,

[1397BusaDK]

Thanks , I will make some brackets for it

[race2win]

What's the.thickness on.the header material some support brackets are always a good idea unless you used some thick wall stuff.you will be fine

[1397BusaDK]

0.079". Or 2 mm

[1397BusaDK]

all the weldings are purge welded

[turbobusadk]

D... good job. Well done

[Justa1k]

That's some good looking fabrication right there

[shoyass]

Nice fab work. 16" front wheel?