07 gsxr 1000 need a little more power

[90mph]

want to keep it stock bore an crank all motor wt else can be done to get a better performance out of it...??\

whats a super sport motor i see they make good power ????????

[solow1k]

Degree the cams, mill the head, thing gasket, good fuel, good tune, good bearings

[90mph]

ok stock cams or after market ones

[solow1k]

Stock cams will give you more power. As well a ported head or high compression stock bore build. Lots of different options. What kind of power do you want the bike to make? budget?

[Cycle Concepts]

come see me..803.285.8093

[conan1k]

Im trying to do the same !!!! Any suggestions (cams, tuning, fuel)

[d3coy]

head and cams on a nice chassis should roll pretty good.

[johnmiffco]

head and cams on a nice chassis should roll pretty good.

suspension,,,suspension,,,suspension,,,,,,,,
very fined tuned stock 07 motor on mr12,,,,,
combined with a working drag suspension
will get flat 9s,,,,,,,,,,
with head and cam package upper 8s

its not all in the motor,,,,
gotta combine it with suspension and rider

[whitegsxr600nj]

i have the same bike. I was running 9.20's foot shifting. got a airshifter and installed a bottle hoping for high 8's. Hope this helps.

[mr660]

suspension, weight, fuel, tune, and tire pressure... i gotta 05 1000 light weight low pro tank chromoly at 65 marvic wheels tuned runnin on mr9 went ah 8.78

[d3coy]

suspension,,,suspension,,,suspension,,,,,,,,
very fined tuned stock 07 motor on mr12,,,,,
combined with a working drag suspension
will get flat 9s,,,,,,,,,,
with head and cam package upper 8s

its not all in the motor,,,,
gotta combine it with suspension and rider

that's why i mentioned the chassis. i've seen a bike with a stage 1 turbo on a stock height/stretched 1000 get spanked by a stock motor with a proper setup. high HP doesn't mean much if you can't get it to the ground and keep the front down. power alone may be enough to beat up on the rookies, but a seasoned rider on a solid setup won't go down so easy.

[johnmiffco]

[QUOTE=d3coy;535470] that's why i mentioned the chassis.

yea i knew you did,,,,,,why i joined in with suspension
and rider

[conan1k]

Any ideas on swapping out the cams??

[ONEFASTGSXR]

whats the best cam set up for 07 1000 stock bottom end. tiforce pipe 2ndaries out. No Nos. Just for strong tune motor. I want it to run hard ontop end. Whats a Good intake and Exhaust cam to use and degree to start with. Id like to buy the cams and be able to keep them in the bike for when i upgrade to a 3 or 4 mil. but for now. im like to know. whats a good cam setup for a stock bottom end motor?

[johnmiffco]

yosh r type r