Wave washer in clutch!

[B-RACER]

Yup looks like it to me thats why i asked if it was thin..with out it the metal will wear away at the aluminum....look further into it to prevent damage on the future..

[knecum]

I believe you, but why in the hell was it in behind te pressure plate? It didn't fall out until I moved the pressure plate

because whoever worked on it don't know what the f their doing!!

[BATTMAN]

does this look familiar

[knecum]

does this look familiar

There not wave though, but depending on its size it could be one of them that someone forced into a wave shape..

[Pruitt'sBusa]

I would definitely pull starter cover and disassemble and inspect in there. Might also be good idea to drop oil pan and make sure there's no other surprises.

[Moody]

usually when i have extra parts left over form a build i throw them behind the pressure plate also. great hiding spot! lmao

[JLANG]

Okay starter pulled the wave washer was there, looked alot different though. I believe it is one of the small washers that come with the Brock's clutch mod.. I went ahead an pulled the pan an nothing luckily, Changed filter also just in case. So I put it all back together and rode down the street, seems fine.. But still hate having extra parts..

[JLANG]

There not wave though, but depending on its size it could be one of them that someone forced into a wave shape..

Looks like the small one but wavy

[BATTMAN]

Did you take the legs off the brocks mod to make sure one of them wasnt missing a washer? Wiggle each of them to see if one of them is loose.

[JLANG]

Did you take the legs off the brocks mod to make sure one of them wasnt missing a washer? Wiggle each of them to see if one of them is loose.

Oh the Brock mod, where do the small washers go, behind the stubs

[JLANG]

I figured what it was, took off a stud and that was the stub base... Not sure how the hell it was waved though!?!? Thanks everyone!!

[B-RACER]

Glad you figured it out,looked alot bigger in pic ..and prob got bent being in there bouncing around..real lucky didnt break anything..

[Moody]

probably at one time when the spring bolt was removed the stud came with it so the washer dropped out into the open area behind the pressure plate, loctite the studs in so that wont happen again

[knecum]

probably at one time when the spring bolt was removed the stud came with it so the washer dropped out into the open area behind the pressure plate, loctite the studs in so that wont happen again

either that or it was pinched when the standoff was bolted down, it was hard to tell how big it was from the pic. when you took off one off the springs did one of the standoffs come off with it? that sometimes happens..i think those tiny washers are flat when new, but maybe not

[JLANG]

either that or it was pinched when the standoff was bolted down, it was hard to tell how big it was from the pic. when you took off one off the springs did one of the standoffs come off with it? that sometimes happens..i think those tiny washers are flat when new, but maybe not

Yes one did come off but that was after I found the washer lol... I'm just thankful it stayed there and no where else!!!!