WILL TAPPING TACH NOT WORK USING NOS MINI ?

[PRICELESS]

IM FIXING TO PROGRAM MY MINI I HAVE THE TACH WIRE TAPPED FROM THE ECU DO I HAVE TO CHANGE TO A COIL GROUND AND SET AT CYLINDERS AT 02 TO WORK ON A BUSA CORRECTLY . IM GUESSING THATS THE ONLY WAY TO GET RPM ABOVE 9999 FOR EXAMPLE STARTING % 6000 SET TO 30 AND CUT OFF 11000 SET TO 5500 ...SOUND RIGHT ??

[xclr82xtc]

you have to hook it to the coil (-), the wire going to the dash is a data wire i beleive. not sure on the busa, but c08 is the correct setting on a gsxr 1k

[jblankenship]

need negative coil as stated above. Then yes set it for cylinders 02. Then set everything for half values. My 1000 is that way set at 3300 and 6700.

[PRICELESS]

thanks guys ill just t beside one of my airshifter taps.

[jblankenship]

just tap onto one of the airshifter kill wires so you dont have another cut on the ecu coil wires

[PRICELESS]

just tap onto one of the airshifter kill wires so you dont have another cut on the ecu coil wires

I WAS THINKIN THAT MYSELF ....BUT TO MUCH THOUGHT LED ME TO JUST HIT THE COIL WIRE ....HA HAH HA I THOUGHT THE BOX MAY INTERUPT IT SOMEHOW !! THANK J !

[jblankenship]

no problem. It will be fine either way. Best way to get the window switch dialed in in my opinion is to run an led off the solenoid wires and mount it in the dash. I do this on all my bikes. The run through the rpms on the nitrous on but the bottle off. Make sure the light goes out about 1-200 rpm before the limiter then your set.