Question on hooking up my pushbutton, I've been having nonstop kill issues with the bike not wanting to go into gear (2nd thru 5th) under load, so I have chop throttle then hit the button. Shifts fine in bench of course. The trans is rebuilt and new shift forks. This was happening before the rebuil. So trouble shooting I wanna make sure the button is hooked up right. I see the instructions state red common, blue normally closed, green normally open. I've got the*red hooked to power and the green hooked the blue mps signal and the blue button wire not connected to anything. Please tell if I got this hooked up wrong. I definitely out of options on these shifting issues. As always, thanks guys!