Arc2 and air don't mix!!!?

[pine]

I have a 09 zx14 and just put a dyna arc2 ignition system on it.The ignition works fine but my problem is my existing nlr air kill for the air shifter no longer works,it has power but no kill when you hit the shifter button. I hooked the arc2 straight to the coils and piggy backed the ignition kill on top. I'm not using the restrike or retard portions of the ignition so i left those unhooked and was told that would be fine.i only need to use the 2 step or launch portion of the ignition. any help would be appreciated.

[Marion Ford]

use the kill output from the nlr box into the 2 step on the arc.
it will kill the eng over the 2 step setting (wont shift on the return road at low revs).

[Anthony2103]

I got rid of the ignition kill and went with a diga kill, it doest mess with the coils at all

[NLRsystems]

move the ikm coil wires to the wires going into the arc 2 not the ones at the coils and try it.

[pine]

which output from the nlr box do i hook to the two step,is it the output marked act? If so do i run it straight to the 2 step on the arc.do i then take the nlr plugs out of the loop at the coil or leave them hooked up

[pine]

got it sorted out,i unhooked all the nlr wires from the coils and hooked the activation wire from the nlr to the launce wire on the arc2.problem solved! thanks for your help marion and seb!