HOW TO CLEAN MY BAMSHEE CARBS

[badboyracing]

OK got banshee with keihin carbs and its bogging bad 1-2 gear got to rev it realy high for it to go idle fine thay told me to clean the carbs took them apart and thay are clean but cleaned them anyway any pick of what to clean on them there are not to many parts on the carbs to clean any help will be appreciated my k&n filters where very clogged up

[knecum]

take the pilot jet out and run a peice of wire through it out of a bristle brush , the pilot is next to the main tube and comes out with a small flat head screw driver

[badboyracing]

take the pilot jet out and run a peice of wire through it out of a bristle brush , the pilot is next to the main tube and comes out with a small flat head screw driver

cool thanks

[Lastman]

Also check the needle and seat that is attached to the floats. If it is gummed up it will not allow the fuel to flow properly.

[badboyracing]

Also check the needle and seat that is attached to the floats. If it is gummed up it will not allow the fuel to flow properly.

I clean them carbs better than new the bike ran better but still bogging

[Lastman]

What was the bike jetted for on fuel mixture. 32:1 or 50:1 and what type of oil and fuel are you using?

[badboyracing]

What was the bike jetted for on fuel mixture. 32:1 or 50:1 and what type of oil and fuel are you using?

my mix is ******* 4oz per gal

[Lastman]

That is 32:1, also I assume the filters are clean.lol

[phill]

P M and give me # I am a banchee freak I 14 mill on dmx with nos