lowering the front on a 07 zx10r

[slickfist]

i have seen several pics of 07s with the forks slid up and wondering how it is done. how are they getting a good clamp on the tapered part of the tubes?

also, has anyone tried the trac dynamics slammerz kit for internal lowering?

[shinobi1]

Some get the forks milled or some used forks from earlier model 1k's and then internally lower, all depends on how low you tryn to get.

[mr.bzx7]

I could go 1.800 inches on my 09 thru the triple clamp

[Steve 10r]

I have mine at 2 1/4 from the tree and it works just fine that's on an06 zx10r

[benzx7r]

it works just like any other bikes with lowering the front. use loosing the bolt, measure and retighten the bolts.

[slickfist]

so the taper doesnt matter? looking at it i didnt think i could get a good clamp on the smaller portion of the tube.

thanks for the replies

[mr.bzx7]

so the taper doesnt matter? looking at it i didnt think i could get a good clamp on the smaller portion of the tube.

thanks for the replies

I wouldn't try to clamp them on the small portion, those who do shim the forks to make up the difference.